中文Rotary pump manufacturer: Common faults of rotary pumps
2020-09-24
I'm not sure what everyone knows about stainless steel plate rotor pump manufacturers? The sludge rotary pump operates based on the relative speed between the motor rotor and the pump casing, and is mainly used for transporting substances with high viscosity. Its volume is not too large, and its compact structure holds a crucial influence in industrial production.
There are quite a few reasons that can cause excessive current flow in the sludge rotary pump. Here, I will provide you with a brief and detailed introduction to many of them. Firstly, everyone should investigate the problems at the shaft or rolling bearing level to see if there is any relative horizontal damage to the rolling bearing. If there is any, it is suggested to immediately rescue it. If it cannot be saved, we can carry out dismantling and replacement of this matter. Secondly, everyone needs to check the motor of the rotor pump manufacturer. Common motor faults can also cause excessive flow in the rotor pump factory's household appliances. In the end, everyone should focus on the entrance and exit pipelines. If there is a slight blockage in the entrance and exit pipelines, it will cause the working pressure at the entrance and exit to become increasingly, very high. The high working pressure at the entrance and exit resulted in an increase in the current flow. In dealing with such situations, everyone should immediately eliminate the blockage.
What should I do if the sludge rotary pump does not have a total flow rate? I think this question has confused many friends. The rotor pump manufacturer does not have a close connection with the total flow rate and these reasons: firstly, the rotation direction of the sludge rotor pump has changed. According to normal circumstances, the rotation direction of the rotary pump manufacturer is the key to maintaining the operation of the sludge rotary pump, which plays a particularly important role. If the rotation direction of the rotor pump manufacturer changes, there is no doubt that the camshaft sludge rotor pump cannot operate normally and cannot transport materials out. At this point, we need to quickly adjust its orientation back. Otherwise, it will seriously damage the rotor pump manufacturer. Secondly, everyone can check and clear the side pipeline gate valve to see if they have forgotten to open it. In addition, please also check the suction side pipeline gate valve. Whether the suction side pipeline gate valve is closed or the discharge side pipeline gate valve is closed, it will cause the rotor pump manufacturer to have no total flow.
The situation of the rotor pump stopping is still relatively risky, and its occurrence usually means that the motor of the sludge rotor pump has encountered some obstacles, which has caused overvoltage protection. In addition, if the pressure at the entrance and exit is high, it can also cause such situations to transform. Secondly, we can check the adhesion between the shaft and rolling bearings. If the shaft and rolling bearings get stuck, the sludge rotor pump will also stop pumping.
Focus on us
QP Machinery
Qin Ping Machinery (Shanghai) Co., Ltd.
Qin Ping Machinery (Wenzhou) Co., Ltd.
24-hour service hotline: